solid-liquid extraction

英 [ˈsɒlɪd ˈlɪkwɪd ɪkˈstrækʃn] 美 [ˈsɑːlɪd ˈlɪkwɪd ɪkˈstrækʃn]

网络  固液提取; 固液萃取; 浸取

化学



双语例句

  1. The extraction behavior of lanthanides is investigated by using solid-liquid extraction technique.
    用固-液萃取法研究了稀土元素的萃取分离。
  2. Methods The orthogonal experiment was designed with ultrasound time, ultrasound power, solid-liquid ratio and extraction temperature as factors to optimize the extraction process of fucoidan.
    方法采用正交设计,以超声提取时间、超声功率、固液比和提取温度为考察因素,优选了超声波提取海带中褐藻糖胶的最佳工艺。
  3. RESULTS solid-liquid ratio, temperature and time would significantly affect the extraction rate of the soluble polysaccharides.
    方法:通过单因素试验和正交试验,研究了料液比、温度、时间对多糖提取率的影响。
  4. And the solid-liquid separation methods, the effect of extraction temperature on the precious metal extraction, as well as the treatment of the extractants were also tested.
    实验了铂、钯、金活动态金属各种提取液介质中痕量贵金属的稳定性、固-液分离方法、提取温度的影响及提取液的处理方法。
  5. Solid-liquid extraction of copper with di ( 2-ethylhexyl) phosphoric acid into molten paraffin wax
    二-(2-乙基己基)膦酸(P204)-熔融石蜡对金属铜的固液萃取研究
  6. Investigation of Solid-liquid Extraction of Nickel, Cobalt and Copper with Some Organic Phosphorus Acid Extractants into Paraffin Wax
    有机磷酸类萃取剂对铜钴镍的固液萃取研究固相萃取法在***类药物提取中的应用
  7. Determination of selected plant treatment agents-method using high performance liquid chromatography with uv detection after solid-liquid extraction
    固体-液体提取后用uv检验液相色谱高功能植物处理剂使用方法的测定
  8. Application of solid-liquid extraction separation in analytical chemistry ⅰ. extraction of uranium with waxes as solid solvents
    固-液萃取分离在分析上的应用1.石蜡作溶剂时铀的萃取分离研究
  9. Extraction of compound copper ore using NH3 · H2O under high-pressure O2 was studied. The effects of concentration of NH3 · H2O, addition of ( NH4) 2SO4, oxygen pressure, leaching time, leaching temperature and solid-liquid ratio on the copper extraction were investigated.
    对新疆某地混合铜矿采用高压氨浸工艺,考了NH3·H2O浓度、NH4+盐用量、氧压、浸出温度、浸出时间及固液比等因素对浸出过程的影响。
  10. Conclusion The optimum solid-liquid ratio is 1:20, temperature is 100 ℃ and the extraction time is 2h, the extraction degree is 1 time.
    结论最佳工艺为料液比1:20、温度100℃、时间2h,提取次数为1次。
  11. The optimum solid-liquid ratio was1:40, temperature was 80 ℃ and the extraction time was 4h. In this condition, the extraction percent of polysaccharides in longan was up to 21.94%.
    最佳工艺为:料液比1:40、温度80℃、时间4h,在最佳提取工艺时,龙眼的粗多糖提取率可高达21.94%。
  12. Solid-liquid ratio, extraction time, temperature, times were selected as four factors to design the orthogonal test, and the optimum condition of extraction was obtained.
    以料液比、浸提时间、温度、提取次数为考察因素,采用单因素试验及正交试验对芝麻饼粕中木脂素进行了提取条件优化的试验。
  13. The results indicated that the Microwave-pretreatment extraction is superior to the Solid-liquid extraction and Soxhlet extraction.
    并与传统固液浸取法和索氏提取法进行了比较。结果表明,改进了的微波预处理法优于传统的固液浸取法和索氏提取法。
  14. From a practical viewpoint, Solid-liquid ratio, temperature, mass fraction of alcohol and extraction time was considered to be 1:10, 70 ℃, 70% and 12h, respectively, which were close to both the practical production and the theoretical values.
    料液比1:10,浸提温度70℃,乙醇浓度70%,提取时间为12h,这个条件比较贴近实际生产应用,且比较接近理论值。
  15. Separation of Rare Earth Elements by Solid-Liquid Extraction with Microcrystalline Naphthalene and Its Application on Analysis
    微晶萘固态萃取分离稀土及其在分析中的应用
  16. The factors affected on the yield of silymarin in decreasing order were as follows: solid-liquid ratio, extraction temperature, ethanol concentration, extraction time.
    各影响因素对水飞蓟素得率的影响程度由大到小依次为:料液比、萃取温度、乙醇浓度、萃取时间。
  17. The influences of water temperature, concentration of ethanol solution, solid-liquid ratio and extraction times on the yield of total saponins were investigated by an orthogonal design.
    设计正交实验考察了水浴温度、乙醇浓度、料液比和提取次数对总皂苷提取率的影响。
  18. Then, the possibility to extract gelatin using multistage counter-current solid-liquid extraction is investigated.
    在此基础上,实验研究了多级逆流固液萃取技术用于明胶提取工艺的可行性,并对工艺参数进行了优化。
  19. The main research results are shown as follows: ( 1) Based on the principle of solid-liquid extraction, a feasible iron-purification technique for industrial aluminum hydroxide was developed.
    论文的主要研究结果有:(1)基于固-液萃取原理,研究了一项针对工业氢氧化铝的深度脱铁技术。
  20. Extraction temperature, hydrolysis pH, salt precipitation temperature, salt precipitation time, salt dosage and solid-liquid ratio had a significant influence on extraction rate and quality offish oil.
    萃取温度、水解pH、盐析温度、盐析时间、盐用量及料液比对鱼油提取率及品质有显著影响。
  21. Extracted liquid-ethanol ratio in 4 factors has the most obvious effect on extraction ratio of inulin, and solid-liquid ratio secondly, then extraction temperature.
    4个因素中液醇比对菊糖提取率影响最大,其次为料液比、提取温度,提取时间对菊芋菊糖提取率无显著影响。
  22. Based on the stability studies, the multi-stage counter-current solid-liquid extraction technology was used to extract different biological sources of collagen. The production had a narrow molecular weight range and a high concentration. The process was continuous and automatic.
    基于上述稳定性的研究,运用多级逆流固液萃取技术提取不同生物来源的胶原蛋白具有分子量范围窄、提取液浓度高、工艺具有连续自动化等优势。
  23. The influence of solid-liquid ratio, extraction temperature, and extraction time on the yield of salidroside was investigated during water extraction.
    水提法主要考察了固液比、提取时间以及提取温度对红景天苷提取率的影响。
  24. It was investigated that the feasibility of multi-stage counter-current solid-liquid extraction technology for collagen preparation. The process had been optimized for different sources of raw materials.
    实验考察了多级逆流固液萃取技术用于胶原蛋白制备工艺的可行性,并对工艺参数进行了优化,以适用于不同原料来源的胶原蛋白制备。